TL AWD V6-3.7L (2010)
23. Install the boot band on the other end of the boot, and repeat steps 21 and 22.
Outboard Joint Side
1. Wrap the splines on the driveshaft with vinyl tape (A) to prevent damaging the outboard boot.
2. Install a new ear clamp bands (B) and the outboard boot onto the driveshaft, then remove the vinyl tape. Be careful not to damage the outboard
boot.
3. Make sure to check the size of a new stop ring.
NOTICE
To avoid driveshaft and vehicle damage, make sure you install a new stop ring.
