TL AWD V6-3.7L (2010)
Axle Shaft Assembly: Removal and Replacement
Intermediate Shaft Removal
Intermediate Shaft Removal
1. Drain the transmission fluid, then reinstall the drain plug with a new sealing washer:
-
Manual transmission See: Manual Transmission/Transaxle/Fluid - M/T/Service and Repair
-
Automatic transmission See: Automatic Transmission/Transaxle/Service and Repair/Removal and Replacement/ATF Replacement
2. Remove exhaust pipe A:
-
Without SH-AWD See: Engine, Cooling and Exhaust/Exhaust System/Muffler/Service and Repair
-
With SH-AWD See: Engine, Cooling and Exhaust/Exhaust System/Muffler/Service and Repair
3. Remove the right front driveshaft See: Front Driveshaft Removal.
4. Remove the rear warm up three way catalytic converter (WU-TWC) bracket (A).
5. Remove the crankshaft position (CKP) sensor cover (A).
6. Disconnect the CKP sensor connector (A), and remove the sensor harness clamp bracket bolt (B).
