TL AWD V6-3.7L (2010)
8. Place a floor jack under the knuckle, and raise the suspension to load it with the vehicle's weight.
9. Tighten the lower arm A mounting bolt and the lower arm B mounting bolt to the specified torque, then remove the floor jack.
10. Apply a small amount of engine oil to the seating surface of a new spindle nut (A).
11. Install the spindle nut, then torque it. After tightening, use a drift to stake the spindle nut shoulder (B) against the driveshaft.
12. Clean the mating surfaces of the brake disc and the wheel, then install the rear wheels.
13. Turn the rear wheel by hand, and make sure there is no interference between the driveshaft and the surrounding parts.
14. Install exhaust pipe B and the muffler See: Engine, Cooling and Exhaust/Exhaust System/Muffler/Service and Repair.
15. Lower the vehicle .
16. Check the wheel alignment, and adjust it if necessary See: Maintenance/Alignment/Service and Repair.
17. Test-drive the vehicle.