TL AWD V6-3.7L (2010)
5. Remove the wheel speed sensor harness bracket (A) and the wheel speed sensor (B) from the knuckle. Do not disconnect the wheel speed sensor
connector.
6. Pry up the stake (A) on the spindle nut (B), then remove the nut.
7. Remove the front brake disc See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and Repair/Front Brake Disc
Replacement.
8. Check the front hub for damage and cracks.
9. Remove the cotter pin (A) from the tie-rod end ball joint, then remove the nut (B).
NOTE: During installation, install the new cotter pin after tightening the nut, and bend its end as shown.
