TL AWD V6-3.7L (2010)
Transmission Position Switch/Sensor: Service and Repair
Transmission Range Switch Replacement
1. Do the battery removal procedure See: Starting and Charging/Battery/Service and Repair/Removal and Replacement.
2. Remove the air cleaner housing See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner Housing/Service
and Repair.
3. Remove the battery base See: Automatic Transmission/Transaxle/Service and Repair/Removal and Replacement/Automatic Transmission
Removal.
4. Remove the nuts securing the shift cable bracket (A).
5. Remove the spring clip (B) and the control pin (C), then separate the shift cable end (D) from the selector control lever (E).
6. Check the bushing (F) in the shift cable end for proper fit and wear. If the bushing is loose or worn, replace the shift cable See: Automatic
Transmission/Transaxle/Shift Linkage/Shift Cable/Service and Repair.
7. Disconnect the transmission range switch connector.
8. Pry the lock tab of the lock washer (A) on the selector control lever (B), and remove the nut (C), the lock washer, the spring washer (D), and the
selector control lever.