TL FWD V6-3.5L (2009)
Driver/Vehicle Information Display: Service and Repair
Select/Reset/Information Switch Test/Replacement
1. Remove the steering wheel. See: Steering and Suspension/Steering/Steering Wheel/Service and Repair/Removal and Replacement/Steering Wheel
Removal
2. Remove the paddle shifter (+) (upshift switch). See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Shifter A/T/Service and
Repair/Removal and Replacement/Paddle Shifter + (Upshift Switch) or Paddle Shifter - (Downshift Switch) Replacement
3. Disconnect the 12P connector (A) from the select/reset/information switch (B).
4. Remove the screws (C), then pull out the center trim (D) from the steering wheel.
5. Remove the screw (E), then pull the select/reset/information switch from the steering wheel.
6. Measure the resistance between select/reset/information switch 12P connector terminals No. 4 and No. 11 in each switch position according to the
table.
7. If the resistance is not as specified, replace the switch.
8. If the switch is OK, but there is a problem with the switch function, check the cable reel subharness and cable reel.