TL FWD V6-3.5L (2009)
Garage Door Opener Transmitter: Testing and Inspection
HomeLink Remote Control System Test
NOTE:
-
Explain to the client that garage door remote transmitters come in two types: fixed code and rolling code. Each type has its own programming
method, and each method is covered in the owner's manual.
-
If the HomeLink will not open the client's garage, do the following procedures.
1. Press any of the buttons on the HomeLink unit.
-
If the red indicator comes on, go to step 4.
-
If the red indicator does not come on, go to step 2.
2. Remove the roof console. See: Body and Frame/Interior Moulding / Trim/Console/Testing and Inspection
3. Measure the voltage between terminals No. 1 (+) and No. 2 (-) of the roof console 20P connector (A). There should be battery voltage.
-
If the voltage is not as specified, check for these problems:
-
A blown No. 16 (7.5 A) fuse in the under-hood fuse/relay box.
-
A faulty under-dash fuse/relay box.
-
An open in the wire.
-
Poor ground (G401).
-
If the voltage is specified, go to step 4.
4. Make sure the Genie remote transmitter (test remote) has fresh batteries.
5. Clear any previously learned codes by pressing and holding the two outside buttons (A) on the HomeLink unit (B) for until (about 20 seconds) the
red indicator (C) on the unit starts blinking, release the buttons.
6. Point the test remote transmitter (A) straight up exactly 4.0 in. (101.6 mm) away from the HomeLink unit (B).
7. Press and hold the test transmitter button and one of the HomeLink unit buttons (C) at the same time.
