TL FWD V6-3.5L (2009)
Cowl Moulding / Trim: Service and Repair
Cowl Cover Replacement
Special Tools Required
-
KTC trim tool set SOJATP2014*
*Available through the Acura Tool and Equipment Program.
NOTE:
-
Put on gloves to protect your hands.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
-
Take care not to damage the body.
1. Remove these items:
-
Windshield wiper arms See: Wiper and Washer Systems/Wiper Motor/Service and Repair
-
Engine compartment cover See: Access Cover/Service and Repair
2. Remove the cowl cover (A).
-1 Remove the clips (B).
Detach the clips (C, D, E) by carefully pulling the cover up.
-3 Release the hood hinge covers (F) from both hood hinges (G).
3. If necessary, release the hooks (A), then remove the A/C intake umbrella (B).
4. Install the covers in the reverse order of removal, and note these items:
-
If the clips are damaged or stress-whitened, replace them with new ones.
-
Push the clips and the hooks into place securely.
-
Make sure the hood hinge covers are seated on the cowl cover securely.
-
Make sure the washer tube is connected properly.