TL FWD V6-3.5L (2009)
12. For some models: Detach the harness clips (A).
13. Remove the outer handle base (A).
-1 Detach the rod fastener (B).
-2 Disconnect the outer handle rod (C) with a clip remover.
-3 Loosen the nut.
-4 Release the hook (D), and slide the outer handle base forward to release the special bolt (E) from the door panel.
14. Remove the rod fastener (A) from the outer handle base (B), then replace it with a new one.
15. Install the handle in the reverse order of removal, and note these items:
-
Reinstall the lock cylinder (driver's door) or the outer handle holder (passenger's door) before installing the outer handle cover.
-
Make sure that the connectors are plugged in properly, and that the cylinder cable and the outer handle rod are connected securely.
-
Make sure the door key cylinder/door locks operate properly.
-
Make sure the door handle works properly.
-
Make sure the plastic cover on the door is installed properly and sealed around its outside perimeter to seal out water.