TL FWD V6-3.5L (2009)
![background image](/acura/tl_fwd/v6-3.5l/Page-3065001.png)
Front Door Panel: By Symptom
Interior - Front Door Panel Fabric Pulling Out
09-059
December 23, 2009
Applies To:
2009 TL - ALL
Front Door Panel Fabric Pulls Out Along the Edge
SYMPTOM
The front door panel fabric is pulled out along the trailing edge of the door panel.
PROBABLE CAUSE
The front door panel fabric was cut too short and not glued along the edge.
CORRECTIVE ACTION
Apply spray adhesive to the door panel, and tuck the fabric back into its channel.
TOOL INFORMATION
Plastic Trim Tool: T/N SILTRIMTL10
REQUIRED MATERIALS
3M Super 77 Spray Adhesive:
(One can repairs about 50 vehicles)
WARRANTY CLAIM INFORMATION
In warranty:
The normal warranty applies.
Failed Part:
P/N 83551-TK4-A02ZA
Defect Code:
02502
Symptom Code:
02502
Skill Level:
Repair Technician
Out of warranty:
Any repair performed after warranty expiration may be eligible for goodwill consideration by the District Parts and Service Manager or your Zone
Office. You must request consideration, and get a decision, before starting work.
REPAIR PROCEDURE
1. Replace the standard nozzle tip on the spray adhesive container with one that can accept a small tube into it for a more controlled concentrated spray
needed for this repair.
2. Pull the remaining fabric out of the channel along the entire vertical edge of the door panel.
3. Spray a bead of adhesive under the entire length of the door panel fabric.