TL FWD V6-3.5L (2009)
Rear Door Panel: Service and Repair
Rear Door Panel Removal/Installation
Rear Door Panel Removal/Installation
Special Tools Required
-
KTC trim tool set SOJATP2014*
-
Trim pad remover, Snap-on A 177A or equivalent, commercially available
*Available through the Acura Tool and Equipment Program.
NOTE:
-
Take care not to scratch the door or related parts.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
1. Push on the upper hook (A) with the appropriate trim tool, then pull back the inner handle cap (B) to remove it.
2. Remove the screws securing the inner handle (A).
3. Remove the door grip trim (A).
-1 Insert the appropriate trim tool into the notch (B), and pry out along the edge of the trim to release the hooks (C).
Pull up the trim to release the hook (D).
