TL FWD V6-3.5L (2009)
Trunk / Liftgate Latch: Service and Repair
Trunk Lid Latch Replacement
Special Tools Required
-
KTC trim tool set SOJATP2014*
*Available through the Acura Tool and Equipment Program.
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to scratch the trunk lid.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
1. Remove the trunk lid trim panel. See: Trunk / Liftgate Interior Trim Panel/Service and Repair/Interior Trim Removal/Installation - Trunk Lid
Trim Panel
2. Insert a trim tool through the latch cover (A) opening, and pry on the cover to release the latch tabs (B). Pull on the cover, and release the
projection (C), then remove the cover.
3. Disconnect the trunk lid latch connector (D), and remove the bolts, then remove the trunk lid latch.
4. Note the position of the manual trunk lid opener cable end (A) in the trunk lid latch (B), then remove the cable from the latch. Take care not to
kink the cable.
5. Install the latch in the reverse order of removal, and note these items: