TL FWD V6-3.5L (2009)
Passenger Assist Handle: Service and Repair
Grab Handle Removal/Installation
Special Tools Required
-
KTC trim tool set SOJATP2014*
*Available through the Acura Tool and Equipment Program.
NOTE: Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
1. Lower the grab handle (A), then insert a small flat-tip screwdriver wrapped in protective tape into the notch.
2. Use a KTC trim tool (A) to pull on the small flat-tip screwdriver, and remove the cap (B).
3. Pinch the clips (A) to release the hooks (B), then remove the grab handle (C).
4. Remove the clips (A) by pinching the hooks with a pair of pliers.
5. If the side curtain airbag has deployed, replace the grab handle with a new one. See: Restraint Systems/Air Bag Systems/Service and Repair