TL FWD V6-3.5L (2009)
of the following damage:
-
Any cracks, deformations, or stress-whitened areas in the A-pillar trim
-
Any cracks or stress-whitening in the clip seating surfaces (B)
-
Replace the upper clip (C) with a new one.
-
If the clip (D) is damaged or stress-whitened, replace it with a new one.
7. Temporarily install the A-pillar trim (without the upper clip) to check the overlap between the trim and the headliner. See: Restraint Systems/Air
Bag Systems/Service and Repair Remove the trim and, if necessary, adjust the overlap.
8. Carefully install the new upper clip (A) to the A-pillar trim (B). Be sure that the grommet (C) is nearest to the top of the pin (D) as shown.
9. Reinstall the A-pillar trim (A).
-1 Insert the bottom of the trim into the dashboard (B), then reconnect the tweeter connector (C).
Place the trim over the A-pillar (D) and fit the upper clip (E) and the lower clip into the holes in the A-pillar, then lightly push the trim into place.
-2 NOTE:
Make sure the side curtain airbag is not tucked under the clips or trim ribs.
Do not push too hard on the A-pillar trim. If you push too hard, the clip will be damaged, and it will not hold the trim properly.
Gently tug on the A-pillar trim to verify that all clips are securely fastened.
10. Reinstall the door opening seal.