TL FWD V6-3.5L (2009)
-
Any cracks or stress-whitened areas in the clip seating surfaces (B)
-
Replace the upper clip (C) with a new one.
-
If the clips (D) are damaged or stress-whitened, replace them with new ones.
7. Temporarily install the C-pillar trim (without the upper clip) to check the overlap between the trim and the headliner. See: Restraint Systems/Air
Bag Systems/Service and Repair Remove the trim and, if necessary, adjust the overlap.
8. Carefully install the new upper clip (A) to the C-pillar trim (B). Be sure that the grommet (C) is nearest to the top of the pin (D) as shown.
9. Reinstall the C-pillar trim (A).
-1 Install the bottom hooks (B) of the trim in the rear shelf (C).
Place the trim over the C-pillar (D), and fit the upper clip (E) and the lower clips into the holes (F) in the C-pillar, then lightly push the trim into place.
-2 NOTE:
Make sure the side curtain airbag is not tucked under the clips or the trim ribs.
Do not push too hard on the C-pillar trim. If you push too hard, the clip is damaged, and it will not hold the trim properly.
Gently tug on the C-pillar trim to verify that all clips are securely fastened.
10. Reinstall the rear door opening seal.