TL FWD V6-3.5L (2009)
6. Install the suction line mount bolt (A) to the bracket.
7. Bleed the brake system. See: Brake Bleeding/Service and Repair
8. Install the left and right engine compartment covers (A). See: Body and Frame/Access Cover/Service and Repair
9. Do the VSA sensor neutral position memorization procedure. See: Testing and Inspection/Programming and Relearning/VSA Sensor Neutral
Position Memorization
10. Start the engine, and make sure the ABS and the VSA indicators go off.
11. Test-drive the vehicle, and make sure the ABS and the VSA indicators do not come on.
NOTE: If the brake pedal is spongy, there may be air trapped in the modulator which could then be induced into the normal brake system during
modulation. Bleed the brake system again. See: Brake Bleeding/Service and Repair
