TL FWD V6-3.5L (2009)
4. Remove the brake hose mounting bolt (B), then remove the brake hose.
5. Install the brake hose (A) with the mounting bolt (B).
6. Connect the brake hose to the caliper with the banjo bolt (C) and new sealing washers (D).
7. Install a new brake hose clip (A) to the brake hose (B) on the bracket, then connect the brake line (C). Do not twist the brake hose.
8. After installing the brake hoses, bleed the brake system. See: Brake Bleeding/Service and Repair
9. Do the following checks:
-
Check the brake hose and line joint for leaks, and tighten if necessary.
-
Check the brake hose for interference and twisting.
10. Clean the mating surfaces between the brake disc and the inside of the wheel, then install the rear wheel.
