TL FWD V6-3.5L (2009)
Parking Brake Cable: Service and Repair
Parking Brake Cable Replacement
Exploded View
NOTE:
-
The parking brake cables must not be bent or distorted. This will lead to stiff operation and premature cable failure.
-
Refer to the Exploded View as needed during this procedure.
1. Release the parking brake lever fully.
2. Remove the center console. See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal and Replacement/Center
Console Removal/Installation
3. Remove the wire guide base (A), then disconnect the parking brake cables (B) from the equalizer (C).
4. Without SH-AWD: Remove the heat shield (A).
5. Remove the parking brake cable grommets, and pull out the parking brake cable from the body floor.
6. Remove the parking brake shoes, and disconnect the parking brake cable from the parking brake lever. See: Parking Brake Shoe/Service and
Repair/Removal and Replacement