TL FWD V6-3.5L (2009)
12. Place a rag or a shop towel over the quick-connect fitting (A).
13. Disconnect the quick-connect fitting (A): Hold the connector (B) with one hand, and squeeze the retainer tabs (C) with the other hand to release
them from the locking tabs (D). Pull the connector off.
NOTE:
-
Be careful not to damage the line (E) or other parts.
-
Do not use tools.
-
If the connector does not move, keep the retainer tabs pressed down, and alternately pull and push the connector until it comes off easily.
-
Do not remove the retainer from the line; once removed, the retainer must be replaced with a new one.
14. After disconnecting the quick-connect fitting, check it for dirt or damage; without SH-AWD system, See: Powertrain Management/Fuel Delivery
and Air Induction/Fuel Line Coupler/Service and Repair/Fuel Line/Quick-Connect Fitting Removal with SH-AWD system. See: Powertrain
Management/Fuel Delivery and Air Induction/Fuel Line Coupler/Service and Repair/Fuel Line/Quick-Connect Fitting Removal
15. Do the battery terminal reconnection procedure. See: Starting and Charging/Battery/Service and Repair/Procedures
Without the HDS
