TL FWD V6-3.5L (2009)
9. Loosen the valve on the regulator, and apply the specified air pressure.
Specified Air Pressure:
550-690 kPa (5.6-7.0 kgf/cm2, 80-100 psi)
REAR
10. With the specified air pressure applied, rotate the crankshaft pulley clockwise, and visually check all the intake primary rocker arms (A) and the
intake secondary rocker arms (B) move together.
-
If the intake primary rocker arm and the intake secondary rocker arm move independently, remove the intake primary rocker arm and the
intake secondary rocker arm as an assembly, and check that the pistons in the rocker arms move smoothly. If any intake rocker arm needs
replacing, replace the primary and secondary rocker arms as an assembly, then retest.
-
If the intake primary rocker arm and the intake secondary rocker arm move together, go to step 11.
11. Remove the air pressure regulator, the VTEC air adapter, the VTEC air stop tool A, and the VTEC air stop tool B.
12. Tighten the sealing bolts to 22 N-m (2.2 kgf-m, 16 lbf-ft).
13. Install the cylinder head covers. See: Valve Cover/Service and Repair/Cylinder Head Cover Installation
14. Install the six spark plugs.