TL FWD V6-3.5L (2009)
Valve Cover: Service and Repair
Cylinder Head Cover Removal
Cylinder Head Cover Removal
Front
1. Remove the intake manifold. See: Intake Manifold/Service and Repair/Intake Manifold Removal and Installation
2. Remove the three ignition coils from the front cylinder head. See: Powertrain Management/Ignition System/Ignition Coil/Service and Repair
3. Disconnect the exhaust recirculation (EGR) valve connector (A) and remove the harness holder mounting bolt (B) and the harness clamp (C).
4. Remove the harness holder (D) from the bracket.
5. Remove the front cylinder head cover.
Rear
1. Remove the strut brace. See: Body and Frame/Frame/Structural Brace/Service and Repair
2. Remove the intake manifold. See: Intake Manifold/Service and Repair/Intake Manifold Removal and Installation
3. Remove the three ignition coils from the rear cylinder head. See: Powertrain Management/Ignition System/Ignition Coil/Service and Repair
4. Remove the harness holder mounting bolts (A) and the engine ground cable (B).
5. Disconnect the three injector connectors (C) and the two harness clamps (D).
6. Remove the harness clamp (E) and disconnect the breather hose (F).
7. Remove the harness (G) from the upper cover.
8. Remove the engine hanger bracket (H).
