TL FWD V6-3.5L (2009)
Valve Clearance: Adjustments
Valve Clearance Adjustment
NOTE: Connect the Honda Diagnostic System (HDS) to the data link connector (DLC), and monitor the engine coolant temperature (ECT) sensor 1.
Adjust the valve clearance only when the ECT sensor 1 temperature is less than 100 °F (38 °C).
1. Remove the cylinder head covers. See: Cylinder Head Assembly/Valve Cover/Service and Repair/Cylinder Head Cover Removal
2. Set the No. 1 piston at top dead center (TDC). Align the pointer (A) on the front upper cover with the No. 1 piston TDC mark (B) on the front
camshaft pulley.
3. Select the correct feeler gauge for the valve clearance you are going to check.
REAR
FRONT
