TL FWD V6-3.5L (2009)
Blower Motor: Service and Repair
Blower Unit Removal/Installation
Blower Unit Removal/Installation
1. Remove the passenger's dashboard undercover. See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Passenger's Dashboard Undercover Removal/Installation
2. Remove the passenger's dashboard trim. See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Passenger's Dashboard Trim Removal/Installation
3. Remove the glove box. See: Body and Frame/Interior Moulding / Trim/Glove Compartment/Service and Repair/Glove Box Removal/Installation
4. Remove the harness clips (A), the bolts, and the glove box frame (B).
5. Cut the plastic cross brace (A) in the glove box opening with diagonal cutters in the area shown, and discard it.
6. Release the wire from its harness clip (A), then remove the self-tapping screws, and the passenger's heater duct (B).
7. Disconnect the connector (A) from the blower motor, and detach the wire harness clips (B).
