TL FWD V6-3.5L (2009)
Compass: Description and Operation
Electrical Compass System Description
Overview
The electrical compass sends the azimuth (direction) information in the 8-directions (N, NE, E, SE, S, SW,W, NW) to the audio-HVAC display unit via
the audio unit.
Starting Operation
When the ignition switch is turned to ACCESSORY (I), the electrical compass unit begins to communicate with the audio unit. Then turn the ignition
switch to ON (II), the self-test mode begins automatically.
The self-test function checks for the current voltage, non-volatile memory (NVM), and ROM status in the electrical compass unit. If the unit detects a
malfunction while in the self-test, it indicates a malfunction by flashing compass information segments (CAL and NW) in the audio-HVAC display unit.
The electrical compass unit send the azimuth (direction) information to the audio unit. The electrical compass unit receive the VSP signal from the gauge
control module via the audio unit. The azimuth information is fixed while parked.
Self-Calibration
The electrical compass unit has a self-calibration function. It detects and compensates for magnetic anomalies caused by bridges, subways and large steel
structures. When the vehicle leaves an area with a strong magnetic interference field (2400 mG or more), the electrical compass unit automatically begins
calibrating. If needed, you can manually calibrate the compass. See: Adjustments
Zone Selection
Zone selection is required to compensate for the difference between magnetic North and geographic North. This deviation is referred to as declination,
the compass compensates for declination when you select the zone where the vehicle is located.
Electrical Compass Unit Connector Inputs and Outputs
Electrical Compass Unit 6P Connector
