TL FWD V6-3.5L (2009)
-
Do not insert the pin probes of the tester or a jumper wire into the terminal port.
-
To prevent damage to the connector terminals, do not insert the test equipment probes, paper clips, or other substitutes as they can damage the
terminals. Damaged terminals can cause a poor connection and an incorrect measurement.
Lever-Locked Connector
The SRS unit connectors have a lever lock.
SRS Unit Connectors
Disconnecting
To release the lock, pull the lever (A) while pushing the lock (B) on the outside of the connector, then pull out the connector (C).
Connecting
To reconnect the connector, push in on the connector sleeve (D). As the connector is pressed in, the lever (A) moves to the locked position.
Spring-Loaded Lock Connector
Some SRS connectors have a spring-loaded lock.
Front Airbag Connectors
Disconnecting
To release the lock, pull the spring-loaded sleeve (A) toward the stop (B) while holding the opposite half of the connector, then pull the connector halves
apart. Be sure to pull on the sleeve and not on the connector.
