Fuel Pump/Fuel Gauge Sending Unit Replacement
-
After tightening, make sure the marks are still aligned.
-
After installation, check the base gasket, visually or by hand, to make sure it is not pinched.
5. Connect the fuel tank unit 4P connector, then connect the quick-connect fitting.
6. Reconnect the negative cable to the battery, and turn the ignition switch to ON (II) or press the engine start/stop button to select the ON mode (but
do not operate the starter motor). The fuel pump will run for about 2 seconds, and fuel pressure rises. Repeat this two or three times, then check for
fuel leaks.
7. Install the access panel.
8. Install the rear seat cushion. See: Body and Frame/Seats/Service and Repair/Rear Seat Removal/Installation
9. Install the fuel fill cap.