TL FWD V6-3.5L (2009)
15. Push the locknut against the transmission housing to seat the transmission range switch into the selector control shaft, and tighten the locknut (A)
to 12 N-m (1.2 kgf-m, 8.7 lbf-ft) while holding the selector control shaft (B) with a 6.0 mm wrench (C), then bend the lock tabs (D) of the lock
washer against the locknut.
16. Tighten the bolts (E) securing the transmission range switch to 12 N-m (1.2 kgf-m, 8.7 lbf-ft).
17. Install the control lever (A), the spring washer (B), a new lock washer (C), and the locknut (D) on the selector control shaft (E). Bend the lock tab
of the lock washer against the locknut.
18. Check the connectors for rust, dirt, or oil. Clean if needed, then connect the connector securely.
19. Apply molybdenum grease to the hole in the bushing in the shift cable end. Attach the shift cable end to the selector control lever, then insert the
control pin into the selector control lever hole through the shift cable end, and secure the control pin with the spring clip.
20. Secure the shift cable bracket with the nuts.
21. Install the battery base. See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Service and Repair/Removal and
Replacement/Automatic Transmission Installation
22. Install the air cleaner assembly. See: Fuel Delivery and Air Induction/Air Cleaner Housing/Service and Repair
23. Do the battery installation procedure. See: Starting and Charging/Battery/Service and Repair/Removal and Replacement
24. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode. Move the shift lever through all positions, and
check the transmission range switch synchronization with the A/T gear position indicator.
25. Check that the engine starts in P and N, and does not start in any other shift lever position.
26. Check that the back-up lights come on when the shift lever is in R.
