TL FWD V6-3.5L (2009)
Fuel Filler Hose: Service and Repair
Fuel Fill Pipe Removal/Installation
1. Drain the fuel tank. See: Service and Repair
2. Remove the left rear wheel.
3. Remove the fuel fill pipe cover (A).
4. Disconnect the fuel fill tube:
-
Without SH-AWD: Disconnect the quick-connect fitting (A), See: Fuel Line Coupler/Service and Repair/Fuel Line/Quick-Connect Fitting
Removal and disconnect the fuel fill tube (B) from the fuel fill pipe by sliding back the clamp on the fuel fill tube, then twist the hose as you
pull to avoid damaging the hose or pipe.
-
With SH-AWD: Disconnect the quick-connect fittings (A). See: Fuel Line Coupler/Service and Repair/Fuel Line/Quick-Connect Fitting
Removal
Without SH-AWD
With SH-AWD
5. Remove the fuel fill pipe (A).
6. Install the parts in the reverse order of removal.
NOTE: Before connecting the fuel fill pipe and the quick-connect fitting, check for dirt, and clean it if needed, taking care not to damage the fuel
fill pipe and other parts.