TL FWD V6-3.5L (2009)
12. Disconnect PCM connectors A, B, and C, then remove the PCM assembly (D).
NOTE: PCM connectors A, B, and C have symbols (A=(square), B=(triangle) , C=(circle)) embossed on them for identification.
13. Disconnect the cover (A) and the bracket (B) from the PCM (C).
14. Install the PCM in the reverse order of removal.
15. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.
16. Manually input the VIN to the PCM with the HDS.
NOTE: DTC P0630 VIN Not Programmed or Mismatch may be stored because the VIN has not been programmed into the PCM; ignore it, and
continue this procedure.
17. If the READ DATA (engine oil life) failed in step 7, go to step 20. Otherwise, go to step 18.
18. Select the PGM-FI system with the HDS.
19. Select the REPLACE PCM MENU, then select WRITE DATA, and follow the screen prompts.
NOTE: If the WRITE DATA indicates FAILED, continue with this procedure.
20. If the READ DATA (ATF life) failed in step 9, go to step 23. Otherwise go to step 21.
21. Select the A/T SYSTEM with the HDS.
22. Select the REPLACE TCM/PCM MENU, then select WRITE DATA, and follow the screen prompts.
NOTE: If the WRITE DATA indicates FAILED, continue with this procedure.
23. Select IMMOBI system with the HDS.
24. Enter the immobilizer PCM code that you got from the iN, and use the replacement procedure in the HDS; it allows you to start the engine.
25. If the TP POSITION CHECK failed in step 6 clean the throttle body, See: Fuel Delivery and Air Induction/Throttle Body/Service and
Repair/Procedures then go to step 26.
26. If the READ DATA failed in step 7 or the WRITE DATA failed in step 19, replace the engine oil See: Engine, Cooling and
