TL FWD V6-3.5L (2009)
Engine Control Module: Programming and Relearning
PCM Idle Learn Procedure
PCM Idle Learn Procedure
The idle learn procedure must be done so the PCM can learn the engine idle characteristics.
Do the idle learn procedure whenever you do any of these actions:
-
Replace the PCM.
-
Reset the PCM.
-
Update the PCM.
-
Replace or clean the throttle body.
-
Disassemble the engine or transmission.
NOTE: Erasing DTCs with the HDS does not require you to do the idle learn procedure.
Procedure
1. Make sure all electrical items (the A/C, the audio, the lights, etc.) are off.
2. Reset the PCM with the HDS.
3. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode, and wait 2 seconds.
4. Start the engine. Hold the engine speed at 3,000 rpm without load (in P or N) until the radiator fan comes on, or until the engine coolant
temperature reaches 194 °F (90 °C).
5. Let the engine idle for about 5 minutes with the throttle fully closed.
NOTE: If the radiator fan comes on, do not include its running time in the 5 minutes.