TL FWD V6-3.5L (2009)
Accelerator Pedal Position Sensor: Service and Repair
Accelerator Pedal Module Removal and Installation
Removal
1. Remove the driver's dashboard undercover. See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Driver's Dashboard Undercover Removal/Installation
2. Disconnect the APP sensor 6P connector (A).
3. Remove the two mounting nuts (B), then remove the clip (C). Using a flat-tip screwdriver (D), push the lock (E), then remove the accelerator pedal
pad (F) from the pedal stop (G).
4. Remove the accelerator pedal module.
NOTE:
-
The APP sensor is not available separately. Do not disassemble the accelerator pedal module.
-
If the pedal stop is damaged, replace it by pulling back the carpet (A), and removing the nuts (B), the bolt (C), and the pedal stop (D).
Installation
1. Install the accelerator pedal pad (A) to the pedal stop (B). Slide the pad until it locks with a clicking sound.
