TL FWD V6-3.5L (2009)
Fuel Level Sensor: Service and Repair
Fuel Tank Unit Removal and Installation
Fuel Tank Unit Removal and Installation
Special Tools Required
-
Fuel sender wrench 07AAA-S0XA100
Removal (without SH-AWD)
1. Relieve the fuel pressure. See: Fuel Delivery and Air Induction/Fuel Filter/Fuel Pressure Release/Service and Repair
2. Remove the rear seat cushion. See: Body and Frame/Seats/Service and Repair/Rear Seat Removal/Installation
3. Remove the access panel (A) from the floor.
4. Disconnect the fuel tank unit 4P connector (B).
5. Disconnect the quick-connect fitting (C) from the fuel tank unit.
6. Using the special tool, loosen the locknut (A).
7. Remove the locknut (A) and the fuel tank unit (B).
