TL FWD V6-3.5L (2009)
11. Remove the nuts securing the shift cable bracket (A).
12. Remove the spring clip (B) and the control pin (C), then separate the shift cable end (D) from the selector control lever (E).
13. Check the bushing (F) in the shift cable end for proper fit and wear. If the bushing is loose or worn, replace the shift cable. See: Transmission and
Drivetrain/Automatic Transmission/Transaxle/Shift Linkage/Shift Cable/Service and Repair
14. Disconnect the 4th clutch transmission fluid pressure switch connector (A) and the shift solenoid wire harness connector (B).
15. Remove the bolt securing the harness cover (C), and remove the harness cover from its bracket (D).
