TL FWD V6-3.5L (2009)
-
Make sure nothing is on or under the front passenger's seat.
-
Make sure there is nothing in the front passenger's seat-back pocket.
-
Keep the windows and the moonroof closed.
-
Do all calibration procedures, except test-driving, in the service bay.
-
Make sure the vehicle is on level ground.
-
Keep the A/C and the heater off.
-
Do not touch the front passenger's seat during calibration, unless you are prompted to or when you have completed the calibration.
-
Do not expose the front passenger's seat to sudden temperature changes.
1. Position the front passenger's all the way rearward, and adjust the seat-back to the most forward position. Do not move the seat from this position.
2. Connect the HDS to the data link connector (DLC) (A).
3. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.
4. Make sure the HDS communicates with the vehicle and the SRS unit If it does not communicate, troubleshoot the DLC circuit.. See: Powertrain
Management/Computers and Control Systems/Testing and Inspection/Component Tests and General Diagnostics/DLC Circuit Troubleshooting
5. Drive the vehicle, and accelerate to 20 mph (36 km/h), then stop on level ground.
6. From the Main Menu, select SRS, then SRS, then Calibration, then select SWS INITIALIZATION, and follow the prompts until the calibration is
complete.
