TL FWD V6-3.5L (2009)
Repairs and Inspections Required After a Collision: Service and Repair
Component Replacement/Inspection After SRS Deployment
NOTE:
-
Before doing any SRS repairs, check the DTCs See: Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview for the
less obvious deployed components (seat belt tensioners, front impact sensors, side airbag sensors, etc.)
-
Do not replace the ODS unit unless it is physically damaged or a specific fault was found during DTC troubleshooting.
-
After a vehicle collision, do the ODS unit operation check. See: Air Bag Systems/Testing and Inspection/Component Tests and General
Diagnostics/ODS Unit Operation Check
-
After a vehicle collision, inspect the front seat active head restraints. See: Body and Frame/Seats/Head Rest/Testing and Inspection
After a collision where the seat belt tensioners deployed, replace these items:
-
SRS unit
-
Seat belt tensioners
-
Front impact sensors
After a collision where the front airbag(s) deployed, replace these items:
-
SRS unit
-
Deployed airbag(s)
-
Seat belt tensioners
-
Front impact sensors
-
Dashboard
After a collision where the side airbag(s) deployed, replace these items:
-
SRS unit
-
Side impact sensor(s) (first)
-
Side impact sensor(s) (second)
-
B-pillar lower trim
-
Front seat assembly (impact side)
-
Seat belt tensioners
After a collision where a side curtain airbag has deployed, replace the items for the side(s) that deployed:
-
SRS unit
-
Deployed side curtain airbag(s)
-
Seat belt tensioner(s)
-
Side impact sensor(s) (first)
-
Side impact sensor(s) (second)
-
Rear safing sensor
-
Roof trim