TL FWD V6-3.5L (2009)
Impact Sensor: Service and Repair
Front Impact Sensor Replacement
Front Impact Sensor Replacement
Removal
1. Do the battery terminal disconnection procedure, See: Starting and Charging/Battery/Service and Repair/Procedures then wait at least 3 minutes
before starting work.
2. Remove the front bumper. See: Body and Frame/Bumper/Front Bumper/Service and Repair
3. Left side; remove the bolts (A), then release the intake air resonator (B).
4. Disconnect the left or right engine compartment wire harness 2P connector (A).
5. Remove the TORX bolts (B) using a TORX T30 bit, then remove the front impact sensor (C).
Installation
1. Install the front impact sensor with new TORX bolts (A), then connect the left or right engine compartment wire harness 2P connector (B) to the
front impact sensor (C).
2. Do the battery terminal reconnection procedure. See: Starting and Charging/Battery/Service and Repair/Procedures
3. Clear any DTCs. See: Restraint Systems/Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview
4. Confirm proper SRS operation: Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode; the SRS indicator
should come on for about 6 seconds and then go off.
5. Reinstall all removed parts.
