TL FWD V6-3.5L (2009)
Start / Stop Switch: Testing and Inspection
Engine Start/Stop Switch Test/Replacement
1. Remove the driver's center trim. See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Dashboard
Center Trim Removal/Installation
2. Disconnect the 10P connector (A) from the engine start/stop switch (B).
3. Remove the two screws, and the engine start/stop switch.
4. Check for continuity between the terminals in each switch position according to the table.
NOTE: Make sure the correct test lead (+ or -) is placed on the terminal.
5. Install the switch in the reverse order of removal.