TL FWD V6-3.5L (2009)
Auxiliary Power Outlet: Testing and Inspection
Front Accessory Power Socket Test/Replacement
Front Accessory Power Socket Test/Replacement
NOTE: If all of the front and console accessory power sockets do not work, check the No. 18 (7.5 A) fuse in the driver's under-dash fuse/relay box and
ground (G403) first.
1. Remove the passenger's center trim. See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Dashboard
Center Trim Removal/Installation
2. Disconnect the 2P connector (A) from the front accessory power socket (B).
3. Inspect the connector terminals to be sure they are all making good contact.
-
If the terminals are bent, loose, or corroded, repair them as necessary and recheck the system.
-
If the terminals look OK, go to step 4.
4. Turn the ignition switch to ACC (I), or press the engine start/stop button to select the ACC mode.
5. Measure the voltage between front accessory power socket 2P connector terminal No. 1 and body ground. There should be battery voltage.
-
If there is battery voltage, go to step 6.
-
If there is no battery voltage, check for:
-
Blown No. 23 (15 A) fuse in the driver's under-dash fuse/relay box.
-
Faulty front accessory power socket relay.
-
Poor ground (G601).
-
Without keyless access system: Open in the wire between driver's under-dash fuse/relay box connector D (16P) terminal No. 14 and the ground
(G601).
-
With keyless access system: Open in the wire between the front accessory power socket relay terminal No. 3 and the ground (G601).
6. Check for continuity between front accessory power socket 2P connector terminal No. 2 and body ground. There should be continuity.
-
If there is continuity, replace the power socket; go to step 7.
-
If there is no continuity, check for:
-
Poor ground (G403).
-
Open in the wire between front accessory power socket 2P connector terminal No. 2 and the ground (G403).
7. Remove the screw and socket base (A), then remove the socket (B).
