TL FWD V6-3.5L (2009)
-
Do not spill water or oil on the SRS unit or any of the sensors.
Wiring Precautions
Some of the SRS wiring can be identified by a special yellow outer covering and the SRS connectors can be identified by their yellow color. Observe the
following instructions.
-
Never attempt to modify, splice, or repair SRS wiring.
If there is an open or damage to the SRS wiring, replace the harness.
-
Be sure to install the harness wires so they do not get pinched or interfere with other parts.
-
Make sure all SRS ground locations are clean, and grounds are securely fastened for optimum metal-to-metal contact. Poor grounds can cause
intermittent problems that are difficult to diagnose.
-
Do not use any silicone based cleaners or lubricants on any SRS connectors or terminals.
Precautions for Electrical Inspections
-
Make sure the battery is fully charged when doing electrical test. If the battery is not fully charged, the results of the tests may not be accurate.
-
When using electrical test equipment, insert the probe of the tester into the wire side of the connector (except water proof connector). Do not insert
the probe of the tester into the terminal side of the connector, and do not tamper with the connector.
-
Use a back probe adaptor 07TAZ-001020A. Do not insert the probe forcibly.
