TL FWD V6-3.5L (2009)
9. Remove the cotter pin (A) from the tie-rod end ball joint, then remove the nut (B).
NOTE: During installation, install the new cotter pin after tightening the nut, and bend its end as shown.
10. Disconnect the tie-rod end ball joint from the knuckle using the ball joint thread protector and the ball joint remover. See: Ball Joint/Service and
Repair/Ball Joint Removal
11. Remove the cotter pin (A) from the knuckle ball joint, then remove the castle nut (B).
NOTE:
-
Use the new castle nut during reassembly.
-
During installation, insert the new cotter pin into the ball joint pin hole from the front to the rear of the vehicle, and bend its end as shown.
Check the ball joint pin hole direction before connecting the ball joint.
12. Disconnect the knuckle ball joint from the lower arm using the ball joint thread protector and the ball joint remover. See: Ball Joint/Service and
Repair/Ball Joint Removal
NOTE:
-
Be careful not to damage the ball joint boot when installing the remover.
-
Do not force or hammer on the lower arm, or pry between the lower arm and the knuckle. You could damage the ball joint.
