TL FWD V6-3.5L (2009)
4. Align the lower end (A) of the damper spring with the stepped part (B) of the dust cover lower mount and the lower spring seat on the damper unit.
5. Align the angle of the stud (A) on the damper mounting base (B) with the welded nut (C) on the bottom of the damper unit as shown.
6. Install the damper mounting washer (Without SH-AWD) (A), and loosely install the new self-locking nut (B).
7. Hold the damper shaft with a hex wrench (C), and tighten the self-locking nut to the specified torque value.
8. Remove the damper/spring from the strut spring compressor.