TL FWD V6-3.5L (2009)
Tire Pressure Module: Service and Repair
TPMS Control Unit Replacement
NOTE: Make sure the TPMS control unit mounting bracket is not bent or twisted as this may affect its communication with the initiators and the tire
pressure sensors.
1. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
2. Remove the driver's dashboard undercover. See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Driver's Dashboard Undercover Removal/Installation
3. Disconnect the TPMS control unit connector (A).
NOTE: The TPMS control unit is located on the brake pedal support member (B).
4. Remove the flange bolt (C) from the brake pedal support member.
5. Remove the TPMS control unit (D) with the bracket (E).
6. Remove the TPMS control unit (A) from the bracket (B).
NOTE: To disconnect the TPMS control unit from its bracket, insert a small flat-tipped screwdriver (C) between the TPMS control unit and the
bracket shown in (D) to release the hook, then slide out the TPMS unit.
7. Install the new TPMS control unit in the reverse order of removal.
NOTE: Make sure the TPMS control unit is properly installed. You will hear a click when the TPMS control unit is securely mounted on the
bracket.
8. Connect the HDS, and memorize the tire pressure sensor IDs. See: Tire Pressure Sensor/Testing and Inspection Do not memorize the IDs
automatically.
