TL FWD V6-3.5L (2009)
4. Lube the tire bead sparingly, with a paste-type tire mounting lubricant, and position the wheel so that the tire machine (A) and the tire iron (B) are
next to the valve stem (C) and will move away from it when the machine starts. Then install the tire onto the wheel.
5. With a dry air source, inflate the tire to 300 kPa (3.1 kgf/cm2, 44 psi) to seat the tire bead to the rim, then adjust the tire pressure, See:
Alignment/Service and Repair then install the valve stem cap.
NOTE: Make sure the tire bead is seated on both sides of the rim uniformly.
6. Check and adjust the wheel balance, then install the wheels on the vehicle.
7. Remove the jack stands, and lower the vehicle. Torque the wheel nuts to specification.
8. Connect the HDS, and memorize the tire pressure sensor IDs. See: Testing and Inspection
