TL FWD V6-3.5L (2009)
Wheels: Testing and Inspection
Wheel Runout Inspection
1. Raise the vehicle, and support it with safety stands in the proper locations. See: Vehicle Lifting/Service and Repair
2. Check for bent or deformed wheels.
3. Set up the dial gauge as shown, and measure the axial runout by turning the wheel.
4. Reset the dial gauge to the position shown, and measure the radial runout.
5. If the wheel runout is not within the specification, check the wheel bearing end play, See: Wheel Bearing/Testing and Inspection and make sure
the mating surfaces on the brake disc or the brake disc/drum and the inside of the wheel are clean.
6. If the bearing end play is within the specification but the wheel runout is more than the service limit, replace the wheel.