TL FWD V6-3.5L (2009)
15. Remove the solenoid valve cover (A), the dowel pins (B), and the gasket (C).
16. Replace the gasket with a new one when installing the solenoid valve cover.
17. Disconnect the connectors from shift solenoid valve A, shift solenoid valve B, shift solenoid valve C, and shift solenoid valve D.
18. Measure the resistance of each shift solenoid valve between the connector terminal and the body ground.
-
If the resistance is out of standard, go to step 21 and replace the shift solenoid valve.
-
If the resistance is within the standard, go to step 19 and check the solenoid valve for a clicking sound.
19. Connect a jumper wire from the negative battery terminal to the body ground, and connect another jumper wire from the positive battery terminal
to each solenoid valve terminal individually.
-
If a clicking sound is heard, go to step 20 and replace the shift solenoid wire harness.
-
If no clicking sound is heard, go to step 21 and replace the defective shift solenoid valve.
