TL FWD V6-3.5L (2009)
16. Check the height (A) of the 8 x 53 mm ATF joint pipe (B) between the top (C) of the pipe and the solenoid valve body mounting surface (D). The
height is about 7.0 mm (0.3 in.). If the height is over 7.0 mm (0.3 in.), push the pipe until it bottoms in the accumulator body.
17. Install a new gasket (A) on the transmission housing, and install the 8 x 34.5 mm ATF joint pipe (B) with the filter end into the transmission
housing and the 8 x 25.2 mm ATF pipe (D).
18. Install new O-rings (E) over the ATF joint pipes.
19. Install A/T clutch pressure control solenoid valve C.
20. Check the connector for rust, dirt, or oil, then connect the connector securely.
21. Install the air cleaner assembly. See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner Housing/Service
and Repair
22. Do the battery installation procedure. See: Starting and Charging/Battery/Service and Repair/Removal and Replacement
