TL FWD V6-3.5L (2009)
20. Remove the shift solenoid wire harness connector (A), and replace it. Install a new O-ring (B) on the shift solenoid wire harness connector, and
install the connector in the transmission housing, then go to step 30.
21. Remove the mounting bolts, then remove the shift solenoid valves.
22. Install new O-rings (two O-rings per solenoid valve) (E) on the reused solenoid valves.
NOTE: A new solenoid valve comes with new O-rings. If you install a new solenoid valve, use the O-rings provided with it.
23. Install shift solenoid valve A (black connector) by holding the shift solenoid valve body; make sure the mounting bracket contacts the accumulator
body.
24. Install shift solenoid valve C (brown connector) by holding the shift solenoid valve body; make sure the mounting bracket contacts the bracket of
shift solenoid valve A.
NOTE: Do not install shift solenoid valve C before installing shift solenoid valve A. If shift solenoid valve C is installed before installing shift
solenoid valve A, it may damage the hydraulic control system.
25. Install shift solenoid valve D (black connector) by holding the shift solenoid valve body; make sure the mounting bracket contacts the accumulator
body.
NOTE: Do not hold the solenoid valve by the connector when installing the solenoid valve. Be sure to hold the solenoid valve body.
26. Install shift solenoid valve B (brown connector) by holding the shift solenoid valve body; make sure the mounting bracket contacts the
accumulator body.
27. Connect the harness terminals to the solenoids:
-
YEL wire connector to shift solenoid valve A.
-
RED wire connector to shift solenoid valve B.
-
GRN wire connector to shift solenoid valve C.
-
ORN wire connector to shift solenoid valve D.
28. Install the shift solenoid valve cover, the dowel pins, and a new gasket.