TL FWD V6-3.5L (2009)
4. Remove the brake hose mounting bolt (A).
5. Remove the brake caliper bracket mounting bolts (B), then remove the caliper assembly (C) from the knuckle. To prevent damage to the caliper
assembly or the brake hose, use a short piece of wire to hang the caliper assembly from the undercarriage. Do not twist the brake hose excessively.
6. Remove the two washers (A).
NOTE: During installation, make sure the washers are installed between the brake caliper bracket and the knuckle.
7. With SH-AWD: Raise the stake (A), then remove the spindle nut (B).
8. Remove the rear brake disc/drum. See: Brakes and Traction Control/Disc Brake System/Brake Rotor/Disc/Service and Repair/Rear Brake Disc
Replacement
9. Without SH-AWD: Remove the hub bearing unit (A) and the O-ring (B).
