TL FWD V6-3.5L (2009)
Power Window Control Module: Testing and Inspection
Power Window Control Unit Reset
Reset the power windows after doing any of the following actions:
-
Power window regulator replacement, removal/installation, or repair
-
Power window motor replacement, removal/installation, or repair
-
Window run channel replacement or removal/installation
-
Front passenger's power window switch replacement or removal/installation*
-
Door glass replacement, removal/installation, or repair
-
Power is removed from the driver's power window master switch or front passenger's power window switch while the power window timer is ON.
NOTE: If the front passenger's power window has lost power when the key off timer is ON, it cannot be operated from the driver's switch and must be
reset from the front passenger's power window switch.
Using the HDS
1. Connect the HDS to the data link connector.
2. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode, then enter the vehicle's VIN and mileage at the
prompts.
3. Select BODY ELECTRICAL from the SYSTEM SELECT menu.
4. From the BODY ELECTRICAL SYSTEM SELECT menu, select POWER WINDOWS.
5. From the MODE menu, select ADJUSTMENT.
6. From the ADJUSTMENT menu, select WINDOW RESET for driver's side (passenger's side) window.
7. Follow the prompts on the screen.
8. Confirm that the power window control unit is reset by using the power window AUTO UP and AUTO DOWN function.
Without the HDS
NOTE:
-
Do each bullet in step 4 within 5 seconds of each other.
-
The front passenger's power window must be reset from the front passenger's power window switch.
1. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.
2. Move the power window all the way down by using the power window DOWN switch.
3. Open the driver's door.
4. Do the following four times before going to step 5:
-
Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
-
Push and hold the power window DOWN switch.
-
Turn the ignition switch to ON (II) or press the engine start/stop button to select the ON mode.
-
Release the power window DOWN switch.
5. Confirm that AUTO UP no longer works. If AUTO UP still works, go back to step 1.
