TSX L4-2.4L (2005)
Driver/Vehicle Information Display: Testing and Inspection
Reminder Systems, Control Unit Input Test
Control Unit Input Test
1. Before testing, troubleshoot the multiplex integrated control system using B-CAN System Diagnosis Test Mode A.
Multiplex Integrated Control Unit
2. Remove the left kick panel.
3. Disconnect the under-dash fuse/relay box connectors F, H and P.
NOTE: All connectors are wire side of female terminals.
4. Inspect the connector and socket terminals to be sure they are all making good contact.
-
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
-
If the terminals are OK, go to step 5.
5. Reconnect the connectors, and make these input tests at the connector.
-
If any test indicates a problem, find and correct the cause, then recheck the system.
-
If all the input tests prove OK, go to step 6.
6. Remove the gauge control module.
